Handmade Silver Jewelry by Jo

All the credit for this info goes to Beading Daily!

Trace the contour of the hammerhead for reference on a piece of paper. Make a tracing of both axes of the curve. Take measurements with a caliper if you desire total control over replicating the hammer face prior to the ding.

File down to the deepest depth of the offending mark with a #3 or #2 hand file. Preserve the contour of the hammer face prior to the ding by comparing it to the tracings and measurements you made.

When the mark is filed down and the face profile of the hammer is to your liking, proceed through several grades of sandpaper from coarse to fine until the steel is absolutely smooth and scratch free.

Buff the hammerhead on a polishing arbor with Fabulustre compound until it is polished to a mirror finish. Remove excess compound with a lint-free cloth. Hide the hammer, so no one will ever use it for home repair again.

read comments (0)